Would you like to react to this message? Create an account in a few clicks or log in to continue.
3D-Move Analysis software Ver. 2.1 Released in June 2013.
To get email notification for new topics and newsletter, select "Start watching forum" under the "3D-Move Discussion" and "Newsletter" forums.
Search
 
 

Display results as :
 


Rechercher Advanced Search

November 2024
MonTueWedThuFriSatSun
    123
45678910
11121314151617
18192021222324
252627282930 

Calendar Calendar


You are not connected. Please login or register

The noise of the graphical output under visco-elastic analysis

2 posters

Go down  Message [Page 1 of 1]

wenjingx



After comparison, I found in 3D-Move, the elastic result is very smooth expected, but the visco-elastic result has lots of noise there. Could somebody explain it, please? Thanks!
The elastic result:
[You must be registered and logged in to see this image.]
The visco-elastic result:
[You must be registered and logged in to see this image.]

Elie Hajj

Elie Hajj
Admin

The "noise" in the response is related to the rough pavement surface used in the analysis which is reflected by a dynamic load coefficient (DLC) of 0.218. In order to obtain a smooth response your DLC value should be equal to zero.
Elie

http://www.arc.unr.edu/Software.html

wenjingx



You are right, it does. Thank you very much, Elie.

Sponsored content



Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum